MFlenses - Ein neues Leben im digitalen Zeitalter
MFLenses 2026

Forum für Manual-Fokus-Objektive

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.
Spotlight

Hervorgehobene Partnerplatzierung auf der Forum-Startseite.

Restoring a Trioplan 100mm
Vorheriges Thema anzeigen :: Nächstes Thema anzeigen  


Reply



Hello MFL (o/ this is my first time posting),

I'm trying to restore this Trioplan that I found in a pile of junk for £5! Imagine my excitement, until I realised it wasn't just tarnished but was missing the outer helicoid barrel/mount.

On the plus side - the iris is snappy and the optics, whilst needing a bit of a clean, aren't in too bad shape. So it's worth trying to find the missing part, finding a donor part from a different lens (any ideas what might have used the same machining, whilst holds little value?), or as a last resort I'll attempt using an adjustable helicoid/3d printed weld. I'm a bit "meh" about the last idea, so if anyone has other thoughts then I'm all ears.

The Heliocoid has an outside thread of 43mm, and it needs to clear 55mm where it overlaps the mid barrel section. From pictures it's 30-40mm in length and I don't massively mind which mount it ends up with, but prefer m42. It'll end up on a Lumix S5iix.

On a side note any recommendations for products to clean up the body would be appreciated. It's down to the brass in places so it'll never be a looker!

Cheers.


Reply

I clean those lenes up with a glass fibre pen.

You could also use some 0000 grade steel wool.

Hopefully you can restore it as they are fantastic lenses.


Reply

Welcome Charries1

Congratulations on rare find!


Reply

Charries1 hat folgendes geschrieben::

On a side note any recommendations for products to clean up the body would be appreciated. It's down to the brass in places so it'll never be a looker!

Cheers.


Is it an aluminum lens barrel? If so you might use - after dismanlting and cleaning the lens barrel - use a sandpaper with a very fine grit (starting at 1200 if theres's damage to clean up, and polishing with 2400).

BTW can you separate the triplet lens head from the remaining barrel (as with amyn Leica and Zeiss lenses)? If that's possible you might use a bellows unit for focusing as well ...

S