MFlenses - Ein neues Leben im digitalen Zeitalter
MFLenses 2026

Forum für Manual-Fokus-Objektive

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.
Spotlight

Hervorgehobene Partnerplatzierung auf der Forum-Startseite.

Flash very weak light
Vorheriges Thema anzeigen :: Nächstes Thema anzeigen  


Reply

I got hold of a Hanimex TZ1. with batteries the flash lights up, starts to fill the capacitor and the "ready" light switches on. it does fire, but the light it produces is so dim that it is only visible if you look directly into it.

also once i switch it off the "ready" light remains lit.. and when i press the "test" button the flash does flash (incredibly weak as before) for tens of times.. probably i could press it for a hundred times and it would still fire.

any thoughts about this?

anyone had a similar experience?

thanks
dario


Reply

no one?


Reply

It could be that the flash is on auto and reading the light level when you fire it. If it was bright light when you fired it the flash will appear dim, although
actually it's the time that is adjusted, not the power. The ready light will stay illuminated if the charge has not been fully depleted - this is quite normal.

See if the flash has a manual setting, or try firing it in a dark room. Otherwise, Hanimex quality often leaves a lot to be desired. Wink


Reply

i tested it indoors with rather dim light so i don't think it is the case. but thanks for your input.


Reply

The fact that "ready" stays on and it can be fired again and again is normal, that is just cheap flash, where switch only turns off low side circuit, without turning off high side circuit (for example, canon Speedlite 155A has same behavour).

The light can be weak due to numerous reasons:

1. Dried out capacitor - as they age, they loose the capacity.
2. Defective bulb
3. Problems with circuitry

I'd settle on #2, as most common problem.