MFlenses - Ein neues Leben im digitalen Zeitalter
MFLenses 2026

Forum für Manual-Fokus-Objektive

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.
Spotlight

Hervorgehobene Partnerplatzierung auf der Forum-Startseite.

my new version of power supply for gossen lunasix 3
Vorheriges Thema anzeigen :: Nächstes Thema anzeigen  


Reply



this is a new version
with less current consumption
i tested on my breadboard


Reply



Reply

visualopsins hat folgendes geschrieben::

lm317lz needs a minimun current in order to work
the current of lm317 in lz version is more low than a classic a lm317
you can supply this minimum current with the two resistors or with a load
with 82k and 100k trimmer and with no load ...it will increase the vout so it will be difficult in this case to have 2.7V with no load
i checked it with my breadboard


Reply

this is a new circuit
i built a circuit board with a dip8 socket
i am awaiting for the mcp6041-i/p..



Reply

metallaro1980 hat folgendes geschrieben::
visualopsins hat folgendes geschrieben::

lm317lz needs a minimun current in order to work
the current of lm317 in lz version is more low than a classic a lm317
you can supply this minimum current with the two resistors or with a load
with 82k and 100k trimmer and with no load ...it will increase the vout so it will be difficult in this case to have 2.7V with no load
i checked it with my breadboard


i built a little box and i putted inside the circuit board with mcp-6041 and a lithium 3.7 rechargeable battery 1200mA...current absorption is very little


Reply




Reply

it works up to 2.7V
in practice, across the diode voltage reference we have a voltage drop = 1.235V, and therefore also in the input of non-inverting op-amp.
it is a non-inverting op-amp circuit ...
the formula of vout is ...
vin+ * (1 + (feedback resistor or sum of feedback resistors / resistor or sum resistors ranging in mass)).
in this case
vin+ * (1+ (560.000 + 82000) / (470.000 + 0..100.000))....
now 2.7 / 1.235 ...2.186..
now ... 2.186 - 1 and we have 1.186 ... the total resistance feedback / total resistance ranging in mass must give 1.186
lt1004-1.2 is an updated version of lm385-1.2 with more accuracy and it works with a minimum current = 10uA.


Reply

Battery should last good long time @10uA! Nice work.

Now for some humor: