MFlenses - Ein neues Leben im digitalen Zeitalter
MFLenses 2026

Forum für Manual-Fokus-Objektive

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.
Spotlight

Hervorgehobene Partnerplatzierung auf der Forum-Startseite.

Ilex control box schematic - Does anyone have?
Vorheriges Thema anzeigen :: Nächstes Thema anzeigen  


Reply

The Ilex electronic shutters are widely available, cheap, and of high quality. What makes most cheap is absence of the essential control box.

Building such a control box should be straightforward, given a schematic. Does anyone have the requisite schematic, or do you know where it might be posted on the net?


ETA

No replies yet so here is what I've come up with so far:

http://www.chemie.unibas.ch/~holder/shutter/index.html

As you can see a very straightforward circuit. Most difficult part might be finding a connector to match the one on the shutter/lens. One could always remove the existing connector, I think, and replace both sides instead of struggling to find a match.

In any event, I smell opportunity here for low cost and high quality in terms of both lens and shutter.

For reference:

Melles Griot is apparently the successor firm to Ilex.

Also:

I do not know whether all the various Ilex electronic shutters use the same control box. Does anyone know?


Reply

Forget hose clunky old control circuits, nowadays we have off the shelf microcontrollers like the Arduino:

https://m.flickr.com/#/photos/frostedbutts/10372012754/


Reply

iangreenhalgh1 hat folgendes geschrieben::
Forget hose clunky old control circuits, nowadays we have off the shelf microcontrollers like the Arduino:

https://m.flickr.com/#/photos/frostedbutts/10372012754/


Ian great stuff!!

About 35 years ago I knew an EE named Arduino, an Italian guy. He was working in Milano at that time. I wonder if it's the same guy . . . or his son. Wink


Reply

The way to do it is use an arduino controller with an i/o module and program the arduino to control the shutter.

If you look around the arduino forums and groups, you will find someone who would be able to do it for you I am sure.


Reply

iangreenhalgh1 hat folgendes geschrieben::
The way to do it is use an arduino controller with an i/o module and program the arduino to control the shutter.

If you look around the arduino forums and groups, you will find someone who would be able to do it for you I am sure.


I agree such an approach would work.

It is noteworthy, though, that the dedicated circuitry I referenced in the OP employs a special cap discharge circuit feature to open the shutter, that is, to snap it open. Anyone seeking to duplicate that feature with standard I/O modules might run into a bit of trouble. I've not studied the Arduino I/O modules. Perhaps some customization is possible.

I like the Arduino controller in that it can be programmed in C+. That's surely preferable, at least in general, to trying to program a different controller in assembly language, even though the code is provided.


Reply

You simply use an I/O controller with a capacitor.

No-one outside of industry has bothered with assembler programming for microcontrollers for years.