MFlenses - Ein neues Leben im digitalen Zeitalter
MFLenses 2026

Forum für Manual-Fokus-Objektive

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.
Spotlight

Hervorgehobene Partnerplatzierung auf der Forum-Startseite.

What do you calla tool with two prongs? I need one
Vorheriges Thema anzeigen :: Nächstes Thema anzeigen  


Reply

Aaaarrggghhhh!

Just taken one of my Mamiya 135EE rangefinders for a walk, the one with the working selenium cell meter.

I get nearly home to find that the screw which holds the film advance lever in place has run away. I've walked about a mile so the chance of finding it is nil but have decided instead to take the part from the other one. The screw is wound down/up by means of a tool which locates two small prongs into holes in the top of the screw. Don't know where I'm going to find one, especially as I don't know what it'd be called...

any ideas guys?


Reply

I've used some unusual things that have done the job like:- two nails in a piece of wood and metal dividers (be careful of the sharp points)


Reply

I would try it first with a eraser / rubber, press firmly against the cap and twist. If that doesn't work use a small pair of engineers dividers - carefully. You might need to modify the tips of the dividers a bit to fit, use an oilstone. It's slower - more accurate - and will abrade the hard tips of the dividers, a file might not.


Reply

tikkathree hat folgendes geschrieben::
Aaaarrggghhhh!

Just taken one of my Mamiya 135EE rangefinders for a walk, the one with the working selenium cell meter.

I get nearly home to find that the screw which holds the film advance lever in place has run away. I've walked about a mile so the chance of finding it is nil but have decided instead to take the part from the other one. The screw is wound down/up by means of a tool which locates two small prongs into holes in the top of the screw. Don't know where I'm going to find one, especially as I don't know what it'd be called...

any ideas guys?


Try a hardware/automotive store, there are sets of "tamper-proof" defeating bits that include something similar -
http://www.amazon.com/Klein-32525-32-Piece-Tamperproof-Bit/dp/B0015S4JRG


Reply

The tool is called a spanner, and an adjustable spanner wrench is probably the tool you want to buy if you plan on disassembling cameras and lenses frequently. Personally I've found that I can usually make do with the tips of a vernier caliper.