| Vorheriges Thema anzeigen :: Nächstes Thema anzeigen |
| Autor |
Nachricht |
Orio
Anmeldungsdatum: 24.02.2007 Beiträge: 29545 Wohnort: West Emilia
Expire: 2012-12-04
|
 Verfasst am: Mo Mai 28, 2012 8:58 am Titel: Loading bulk film |
|
 Verfasst am: Mo Mai 28, 2012 8:58 am Titel: Loading bulk film |
|
|
Orio wrote:
OK, so I have this box of ADOX CHS 50 (=Efke) in front of me, and no instructions.
If I open the plastic box, does the film immediately get exposed to light? Or is there an intermediate something (like plastic bag)
And when I have it open into the changing bag, does the tail of film peek out, or do I have to do something to disengage it?
Any other useful hints for a first-timer?
thanks _________________ Orio, Administrator
T*
NE CEDE MALIS AUDENTIOR ITO
Ferrania film is reborn! http://www.filmferrania.it/
Support the Ornano film chemicals company and help them survive!
http://forum.mflenses.com/ornano-chemical-products-t55525.html |
|
| Nach oben |
|
 |
mdarnton
 Anmeldungsdatum: 03.03.2012 Beiträge: 79 Wohnort: Chicago
|
 Verfasst am: Mo Mai 28, 2012 12:42 pm Titel: |
|
 Verfasst am: Mo Mai 28, 2012 12:42 pm Titel: |
|
|
mdarnton wrote:
I don't know how Adox does it, but usually when you get to a lightproof container closed with tape around the seam, that's when you turn off the light. Inside you will probably find a black plastic or paper bag that shouldn't be trusted on its own in light--it's there as an additional light baffle. Inside that will be a roll of film on a core, only--no side flanges like movie film, and there will be a small piece of tape keeping the loose end down.
I spool my film in the dark. I get a number of cassettes in one place, scissors in reach, cut as many three-inch strips of masking tape as cassettes and put them along the edge of my sink (only a bit taped, most of the length hanging out into the air, easy to find and remove) then turn off the light. I open the film, and stretch off one length. For me, the right length for 36 exposures is my arm spread, with one hand cocked in at 90 degrees. Cut off that length, open one cassette, take a piece of tape from the sink edge and tape the film to the spool. The tape should be equally on the front and back of the film, and the film should be perpendicular to the spool and centered, and facing the right direction, of course. Then start winding. The correct direction is emulsion down, film dropping away on the side of the spool away from you when the projection on the spool is in your right hand. I lick my fingers to get more traction on the spool end and start spinning.
Between rolls, you can just drop the film in the can, since you're not going to be turning the lights on until you finish however many rolls you're doing at once, but when you are finished for the day, put it back in the black bag, too.
I can do eight rolls before I get bored.
When the film is all wound on the spool, squeeze the film so that it doesn't unwind and expand, slide it into the cassette and put on the cap. Make sure everything is going in the right direction (load the camera in your mind if you don't know which way is up). On to the next roll . . . .
If you work in the dark, you don't lose the last two frames on the roll as you would with a daylight loader, and once you get used to it, it's faster. I use a bathroom in my basement that's totally dark and has no windows. It needs to be completely dark! No cheating on that! I have always managed to find some place--a closet at night, with no lights on, or something. If you need to, jam a towel along the bottom of the door. _________________ small formats: http://flickr.com/mdarnton
large format: http://flickr.com/michaeldarnton
http://mdarnton.tumblr.com |
|
| Nach oben |
|
 |
Minolfan
 Anmeldungsdatum: 30.12.2008 Beiträge: 3451 Wohnort: Netherlands
|
 Verfasst am: Mo Mai 28, 2012 1:13 pm Titel: |
|
 Verfasst am: Mo Mai 28, 2012 1:13 pm Titel: |
|
|
Minolfan wrote:
That is too long ago for me.
AFAIK the film is packed is a light tight bag in the can. But I wouldn't risk it and open the can in the changing bag.
I think the rol is kept in model with a piece of tape, not difficult to get it off in the darkness of the bag.
Put the rol in a daylight filmloader, a small tip of the film coming outside.
Then you can start with a piece of tape to fasten the spool of a cannister to the film. Close the cannister and close the filmloader, with the cannister correctly in its place. If there is no counter on te loader, you have to find out how much times to turn, before you have the 1.60m (36 pics). I don't remember the number of turns for 36 and 24 pics and its not noted in my little old excersize booklet that I used till 30 years ago
Found the turns I believe: http://www.instructables.com/id/How-to-use-a-35mm-film-bulk-loader/
36 pics = 31 turns
24 pics = 24 turns
I found recently a "computurized" filmloader on a thriftmarket for € 10. On the outside is visible a frame counter and the rest of the meters film. |
|
| Nach oben |
|
 |
Orio
Anmeldungsdatum: 24.02.2007 Beiträge: 29545 Wohnort: West Emilia
Expire: 2012-12-04
|
 Verfasst am: Mo Mai 28, 2012 1:33 pm Titel: |
|
 Verfasst am: Mo Mai 28, 2012 1:33 pm Titel: |
|
|
Orio wrote:
Thank you guys!
I have an AP loader, there are some very basic instructions on how to operate it, but no explanation about how the big film roll is packed and how to unpack it.
I'll first try to get familiar with the daylight loader then maybe try without.
I think that bulk film producers could at least provide the cassette with a drawing showing how the film is packed inside
It's the same old story, for people used to the procedure it's so useless information that they think it is not needed, so this way the first time users are left in the dark (pun intended)  _________________ Orio, Administrator
T*
NE CEDE MALIS AUDENTIOR ITO
Ferrania film is reborn! http://www.filmferrania.it/
Support the Ornano film chemicals company and help them survive!
http://forum.mflenses.com/ornano-chemical-products-t55525.html |
|
| Nach oben |
|
 |
Minolfan
 Anmeldungsdatum: 30.12.2008 Beiträge: 3451 Wohnort: Netherlands
|
 Verfasst am: Mo Mai 28, 2012 11:02 pm Titel: |
|
 Verfasst am: Mo Mai 28, 2012 11:02 pm Titel: |
|
|
Minolfan wrote:
Always exciting, doing things in the dark you never did before.
Discovering what should be made clear in a manual indeed.
I wish you good luck! |
|
| Nach oben |
|
 |
Attila
 Anmeldungsdatum: 24.02.2007 Beiträge: 58002
Expire: 2025-11-18
|
 Verfasst am: Mo Mai 28, 2012 11:42 pm Titel: |
|
 Verfasst am: Mo Mai 28, 2012 11:42 pm Titel: |
|
|
Attila wrote:
Not difficult, practice your bulk loader on light with a simple 35mm roll what is take off from cartridge.
Once you get practice , try same in dark.
Finally go to full dark with bulk film ,basically just a bigger roll than simple 35mm roll and repeat again what you know already well.
Bulk rolls come with metal or plastic box with black plastic bag inside or paper cover on bulk film you can open it easily in dark. |
|
| Nach oben |
|
 |
|
|
|
Du kannst keine Beiträge in dieses Forum schreiben. Du kannst auf Beiträge in diesem Forum nicht antworten. Du kannst deine Beiträge in diesem Forum nicht bearbeiten. Du kannst deine Beiträge in diesem Forum nicht löschen. Du kannst an Umfragen in diesem Forum nicht mitmachen.
|