MFlenses - Ein neues Leben im digitalen Zeitalter
MFLenses 2026

Forum für Manual-Fokus-Objektive

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.
Spotlight

Hervorgehobene Partnerplatzierung auf der Forum-Startseite.

Canon FD 85 f1.2 L - balls everywhere :)
Vorheriges Thema anzeigen :: Nächstes Thema anzeigen  


Reply

Hi

This lens belongs to our member - Omar.

The lens is going to be given EF mount but Omar had previously complained about stiff focusing --

I opened the lens to inspect it and see what the reason for stiff helicoid could be.

ouch! -- this hurts!

bearing balls where everywhere!! - I usually do not go too far with disassembly but it was unavoidable in this case

Those scratches are gone as they were only traces after bearing balls - the glass is clear now - good news





















tf


Reply

Wow, I did not know a lens needed that much bearing balls. It looks like an infestation! Shocked

What's the source of those bearing balls?


Reply

The lens has basically two bearing rings - one is inside (broken as seen on pictures)

I think that is not very good idea by Canon - but never mind - I am not a lens engineer Smile

Another bearing mechanism is placed in the mount - that one was OK in this case

My thought - unconfirmed - Someone broke the lens by turning the aperture mechanism - usually people do try to open the aperture on FD lenses and they do not know how to open it.


Reply

Thanks for the explanation - the lenses I've disassembled usually have only one bearing ball for the diaphragm click stops Smile


Reply

and --- gathered balls Smile



tf


Reply

Wow, they need all those ball bearings for the lens?


Reply

Lifetime supply of bearing balls Laughing

So are you going to put the balls where they were originally? Or skip them altogether? The suspense is killing me Wink


Reply

My trombone zoom is a great lens but the mechanism became sticky (jerky) there was a small trace on the barrel which seemed to me that a small piece of grit had gone under the slide.

So genius even found a schematic diagram of the lens and thought that if the slide lock was removed the barrel could simply be cleaned.

Out come four tiny easily removed screws and about 200 micro ball bearings followed quickly thereafter.

Inside the mount there is a horizontally opposed open double ball race one facing in each direction. The barrel fitting is the only thing keeping them in place.

I could not see how anyone could ever manage to fit or replace such small bearings under this circumstance - back to canon for an expensive repair caused by a simple attempt to clean. Someone told me they used magnets to get them in there.

I subsequently found that approximately one in ten of these lenses have that barrel stiction problem. What happens is that the whack of the slide hitting against the non-damped end of the travel can jump one or more bearings out of it's race. This then first gets under the slide and causes that sticky feeling - and the trace mark on the barrel I saw was a sign of this. The bearings can then often travel into the lens body itself and interfere with the IS mechanism as well.

Of course it was out of warranty and I had tried to "clean" it myself ...

So be warned that the 85mm f1.2 is not the only Canon lens with open ball races inside.


Reply

A lot of Canon FD lenses have those ball bearings..... I am usually very reluctant to disassemble the rear of these lenses, because it's difficult to put all of those back in the right place!!!!!