MFlenses - Ein neues Leben im digitalen Zeitalter
MFLenses 2026

Forum für Manual-Fokus-Objektive

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.
Spotlight

Hervorgehobene Partnerplatzierung auf der Forum-Startseite.

Arco Tokyo Tele-Colinar 135mm f3.5 mount adaptation?
Vorheriges Thema anzeigen :: Nächstes Thema anzeigen  


Reply

This is in Exakta mount, and i was able to unscrew the mount off after unscrewing the 3 small screws on the flange neck right under the Exakta flange. Having done that I found that it was constructed very differently inside from other Exakta mounts I have seen; the lens mount besides being screwing down -was screwed by the 3 small screws I mentioned before to an inner sleeve . This sleeve does not rotate as it has a slot that makes it slide in and out, but not around.
The throat i.e. the part that the Exakta mount screws on is akin to a uni-adapter .Its a tad wider than a T-mount,and a tad smaller than a T-mount with the inner ring removed.

The main objective of all of this was to see how I could convert to or mount a M42 mount, and maintain infinity. Shaving the back of the mount is out of question as the back of the mount is thin enough where shaving maybe ill advised.
I have posted some images of the partial disassemble-I am keen on hearing what your experience/advise/suggestions may be, specially if you've had a similar lens you've worked on Very Happy

Much regards










Reply

Whats the diameter of the thread ?


Reply

luisalegria-

The diameter of the inner threaded end is 44mm
Thanks


P.S-Check my other new old lens a SUN ,Linked here -looks like following your lead Smile.Although I know I could never never produce the quality of images you do-they're super.
Its got a focus ring that wont budge so far. I've managed to loosen and free up the aperture blades. I was able to test it mounted on bellows -it actually works quite good and with infinity and a much closer "close focusing" distance.

pps-edited stuff about miranda mount out-too much happy sauce when I wrote that Very Happy