MFlenses - Ein neues Leben im digitalen Zeitalter
MFLenses 2026

Forum für Manual-Fokus-Objektive

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.
Spotlight

Hervorgehobene Partnerplatzierung auf der Forum-Startseite.

Auto Tamron 2.8 F135mm Adapta-matic:Dust removal
Vorheriges Thema anzeigen :: Nächstes Thema anzeigen  


Reply

I am asking first before touching(learnt from the komura)
How easy is it to clean out the dust especially the back element as there is an annoying red fibre(plant???) that is sitting on the lens.Plus a lot of other dust through out.I am by no means gifted at doing these things but I can follow clear instructions.


Reply

No idea, should not difficult.


Reply

I suppose the answer I am looking for is like the komura lens I was caught out by a simple spring...still trying to put it back in.....When you start to dismantle a lens for the first time what is the best way to go about it...Start at the front or back.I have googled a bit on trying to understand what I may face by undoing a lens and have come across a few interesting threads but as I assume all lens are not made the same but surely there should be a rule of thumb for all of them??
looks like the cleaning is the easiest part getting in to clean is the hardest.... Laughing


Reply

As a very general rule, I would say start from the back. Of course, it depends on many factors, and there is often little commonality between lenses from the same manufacturer. I learned this back when I used to buy the AI kits from Nikon to convert non-AI lenses to AI. Seemed like every lens design had its own method for linking up to the aperture ring.

Also, because the openings in a lens tend to be larger at the back than elsewhere (usually the focus and/or zoom rings fit tightly enough such that not much dust gets in that way), and these openings are the most often exposed as lenses are swapped out, this is another reason to start at the back. Chances are most of the dust is located closer to the back than the front. The aperture blades are also usually closer to the rear of the lens, and if they need service, you're there.

If you have dust throughout, though, you're pretty much looking at total dismantlement. Take plenty of pics with your digicam.


Reply

Thanks I have to shelve the dusting of this lens and learn on my soligor Confused