MFlenses - Ein neues Leben im digitalen Zeitalter
MFLenses 2026

Forum für Manual-Fokus-Objektive

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.

Entdecke die Welt der Vintage-Objektive mit Reparaturnotizen, echten Testfotos und detaillierten Archiv-Themen voller Bilder.
Spotlight

Hervorgehobene Partnerplatzierung auf der Forum-Startseite.

Cloth FP shutter CLA
Vorheriges Thema anzeigen :: Nächstes Thema anzeigen  


Reply

I have two Spotties which are grossly overexposing at higher speeds. The measured speed of one of them at 1/1000 is only 1/160s and getting worse across the frame, due to a slower 2nd curtain.

I'd like to learn how to CLA the shutters myself. I'm fairly confident about adjusting the spring tension of each curtain but I'm not sure how and where to clean and apply lubrication (if any) and should I be looking at the gap adjustment? Can anyone help with advice or a link?


Reply

just some brief advice... shutter springs seldom wear out, so before you increase the tension on them, look after the cleaning. Pentaxes are relatively easy to work on, because the front panel (including the lens mount) comes off without taking the whole mirror mechanism with it. With the front off you get a bit of a look at the shutter spindles. Once you're satisfied that it's clean and smooth, then look again at the speeds. A TV set or monitor (only the old CRT type, not a flat screen) is a really excellent shutter tester, especially at the fastest speeds, it will tell you if you have both curtains running the same speed as well as a good general idea (close enough for photo use) of what the speeds actually are.


Reply

Thanks Rick. I've already removed the front panel on one of the cameras but I don't understand what needs to be cleaned and lubricated, is it just the ends of the spindles? What about the timing gear and the channels for the curtains?

I'm checking the curtain speeds and exposure times with a tester I built with Jes's help, using 2 photodiodes, and I use a spreadsheet to do the calculations. The results are maybe a lot more accurate than necessary, but it works and it was a fun project to do. But I'd really love to get one of the testers pictured in the Pentax service manual! I've experimented with the curtain spring tensioners on an old defective body, but I haven't yet tried adjusting the timing mechanism, which needs a special tool.

I think I understand what you mean about using a CRT for timing. Adjusting each curtain to the same speed would be simple, but I don't see how to correlate that to actual exposure times. Is there a link or pictures anywhere?

Thanks very much for your help.


Reply

Mostly it's the curtain spindles, for uneven curtain travel. Also any dirt that gets into the gear teeth on the top ends of the spindles at the right-hand end of the camera can cause a curtain to hesitate... but those gears are better protected and less prone to getting dirty in Pentax than, say, a Zorki or a screwmount Leica.

Timing gears are a factor if your slow speeds are hesitant.

Checking actual speeds on a TV is not like reading a number off a display, but you can do it pretty accurately (shutters do not deliver perfect accuracy anyway, and film does not require it)... uniformity across the negative is more important, and that's where a TV outperforms a shutter tester (or at least is quicker and easier to use). Here's a link:

http://rick_oleson.tripod.com/index-135.html